Week 5: Team Blog

-
  • Main presentation one completed
  • Wayside group meeting
  • Team lead group meeting
  • Further increased the accuracy of our calculators to match what will be used at makerfaire 
  • Had a technical conference call with maxwell where we got to ask questions on how the capacitors will behave in our project
  • Decided to stick with four motors in parallel, still deciding on 48 or 24V. 
  •  Decided on what and where our mechanism will be placed and where our thrid and fourth rails will go
    • this might change based on dans idea and the track will be thinner
  •  

Comments

Post a Comment

Popular posts from this blog

4 Weeks remaining: Small Scale Prototype

-
Image
Wayside Power Small Scale Prototype:  Update 4 Weeks remaining Issues this week:   Maxwell has still not gotten back to us, so we have begun to look for cheaper alternatives If we create a supercap bank made up with many 2.7V cells in combination of series and parallel, we will be able to save money. This does cause the charging time to increase to about 4 minuets, up from about 45 seconds, as each cell can only handle about 30A of current vs 2000A with the other more expensive modules.   We will have to solder all of these together.  We will have to create a casing to hold and easily assemble, dissemble.  We can use SAB MOSFETS to balance our series stack and prevent overcharging instead of trying to match a mosfet of the shelf with our ucap modules, this is a good thing! These are specifically designed to be a low cost and low power usage solution to balancing supercaps in series. https://www.digikey.my/en/videos/a/advanced-line...
Read more

Full - Scale Wayside (01/28/2019 - 02/27/2019)

-
Image
Team + Individual (Tynan) Blog (Up until 02/27/2019) Programming:  ATtiny841 ATtiny841 is configured and accepting code from master. (Not through UART but ISP). Explanation of the code can be seen in the flow chart on the ride hand side of the above schematic ("1st Attempt"). Each controller will have to be programmed an a value (controller #1, #2, ... , #n) in EEPROM using EEPROM.write ( EEPROM_ARDUINO ). EEPROM is essentially an extra hard drive with limited space. Things stored in here will remain when the chip is shut off. Using Serial Communications, (Sent in Binary with serial.write( SERIAL_ARDUINIO )) the master can send a value to a specific chip telling it to turn on, read its supercapacitors voltage, send it back to the master and finally turn back off. This method ensures minimum current draw from cells and eliminates the need for a voltage divider (which is constantly drawing power). The slaves are isolated from the master by a device called optoisolat...
Read more